• <i id="snsqc"></i>
    <p id="snsqc"></p>

    1. 0577-63660008
       
      减速电机故障原因与措施
       
      故障
      Malfunction
      原因
      Causes
      措施
      Measures
      在减速机的紧固件处有大的噪声
      High noise at tightening parts
      紧固件松动了
      Loose of tightening parts
      将螺栓/螺母拧紧到规定的扭矩。更换损坏了的螺栓/螺母。
      Tighten nut bolt to correct state Replace damaged nut/bolt
      减速机的噪声变化
      Changing noise
      齿轮的轮齿发生了损坏
      Teeth of gears get damaged
      和客户服务部联系。检查所有零件上的齿,更换损坏了的零件。
      Consult after-sales department
      Check teeth of gears and replace damaged one.
      轴承间隙过大
      Clearance of bearings too big
      和售后服务部联系。
      调整轴承的间隙。
      Consult after-sales department
      Adjust the clearance of bearings
      轴承损坏
      Bearings get damaged
      和客户服务部联系。
      更换损坏的轴承。
      Consult after-sales department
      Replace damaged bearings
      轴承温度升高
      Bearing temperature rise
      箱体里面的油面过高或过低
      Oillevel is too high or low
      在室温下检查油面的高度并按需加油。
      Check oil level at room temperature and add on reduce oil
      油过于陈旧
      Oil is used too long
      和售后服务部联系。
      检查上次换油的时间。
      Consult after-sales department.
      Check the date that oil be replaced last time.
      油泵的机械故障
      Malfunction of oil pump
      和售后服务部联系。
      检查油泵的工作是否正常,修理或换新的油泵。
      Consult after-sales department.
      Check if pump works normally,repair or replace it.
      轴承损坏
      Bearing damage
      和售后服务部联系。
      -查阅操作人员在振动测量中所获得的数据。
      -检查并按需要换轴承。
      Consult after-sales department.
      -Look up the date about vibration.
      -Check and replace it on request.
      工作温度过高
      Working temperature too high
      箱体里面的油面过高
      Oil level is too high
      检查油面的高度,如果有必要的话,调整。
      Check oil level,and adjust if necessary.
      油过于陈旧
      Oil is used too long
      和售后服务部联系。
      检查上一次换油的时间,如果有必要的话就更换。
      Consult after-sales department.
      Check the date that oil was replaced last time,
      replace it if necessary
      油受到严重污染
      Oil is pollucted seriously
      和售后服务部联系
      -换油。
      Consult after-sales department.
      -Replace oil.
      在配备了润滑油冷却系统的减速机上:冷却剂的流量过低或者过高
      Flux of cooling material is too high or low
      全面调节进口和出口管道的阀门。
      检查水冷装置的自由流量。
      Adjust entrance and exit valves.
      Check the flux of water cooling devices.
      通过水冷装置的油流过低,其原因是:滤油器严重堵塞
      Oil flux through water cooling devices is too low
      清理滤油器
      Clean oil filter
      油泵的机械故障
      油泵损坏
      Malfunction of oil pump
      Oil pump damage
      和售后服务部联系。
      -检查油泵的功能是否正常。
      -修理或者换新。
      Consult after-sales department.
      -Check of oil pump works normally.
      -Repair or replace it.
      在配备了风扇的减速机上:风扇罩的空气入口和/或箱体严重污染
      Entrance of fan shield and housing polluted seriously
      清理风扇罩和箱体
      Cleanse fan shield and housing.
      配备了冷却螺旋管的减速机:冷却螺旋管里面结垢
      Redsidues in cooling coil
      和售后服务部联系。
      -清理或者更换螺旋管。
      Consult after-sales department.
      -Claen or replace cooling coil.
      轴承处的振幅升高
      Swing at bearing higher
      轴承损坏
      Bearing is damaged
      和售后服务部联系。
      -检查并按需更换轴承。
      Consult after-sales department
      -Check and replace bearing.
      齿轮损坏
      Gear is damaged
      和售后服务部联系。
      -检查并按需更换齿轮。
      Consult after-sales department.
      -Check and replaces gears.
      止回装置的温度过高
      止回功能的失效
      Temperature of anti-backstop too high and it becomes malfunction
      止回装置损坏
      Anti-backstop becomes malfunction
      和售后服务部联系。
      -检查并按需更换止回装置。
      Consult after-sales department.
      -Replace anti-backstop
      减速机漏油
      Oil-leak of gear unit
      箱体盖或者联接处的密封不良
      Sealing at cover and connection not in good state
      检查密封和连接处,如果必要的话,更换新的。将连接处密封好。
      Check air-proof and connection part,replace them if necessary,and seal up connection part.
      径向轴封失效
      Shaft seal is malfunction
      和售后服务部联系。
      -换新的径向密封环。
      Consult after-sales department.
      油中有水
      Water in oil
      油中有杂物
      Mixer in oil
      用试管检查油的状态是否有水分存在。
      实验室分析油.
      Classify if there is water in oil by using tube.
      Analyse oil in laboratory.
      润滑油冷却器或者冷却螺旋管失效。
      Cooling coil is of mal-fanction
      和售后服务部联系。
      -找出并修理泄漏之处。
      -更换冷却器或者螺旋管。
      Consult after-sales department.
      -Find out and repair leakage place.
      -replace cooling coil
      减速机受到机器间通风过来的凉空气而产生凝露
      Cool air will cause water drop in gear unit.
      用合适的保温材料将减速机保护起来。
      关闭空气的出口或者在结构上改变其方向。
      Shelter gear units with proper
      注:对于客户自己无法排除的故障请和我公司售后服务部联系。
      Note: Please consult after-sales department, if malfunction can not be removed by consumers tehmselves.
       
      0

      在线
      客服

      客服
      热线

      0577-63660008 63660088
      7*24小时客服服务热线

      关注
      微信

      关注官方微信
      顶部

      Copyright ?2018 REDSUN TIMES GROUP All Right Reserved

      浙江瑞德森机械有限公司 版权所有 网站备案号:粤ICP备10211799号

      全国统一服务热线

      0577-63660008

      免费的又色又爽又黄的视频,夜夜澡人摸人人添,色偷偷2019免费视频观看,欧美高清va在线视频 网站地图